Check Setting Of High Beam - AP82.10-P-8260-02A
| AP82.10-P-8260-02A | Check setting of high beam | ||
| Risk of death due to high voltage in xenon headlamps. Risk of explosion/risk of fire caused by hi flammable materials in the vicinity of damaged xenon bulbs. Risk of injury caused by UV light, hot components at xenon headlamps and glass splinters produced by bursting xenon bulbs. Risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming into contact with skin | Do not touch parts conducting high voltage. Persons with active electronic implants (e.g. cardiac pacemakers) must never work on xenon headlamps. Switch off the entire lighting system. Wear insulated safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure sufficient ventilation in the working area. | AS82.10-Z-0001-01A |
MODEL 906
The center of the light beam must lie on the central mark (6) in the headlamp aimer.
Check setting of high beam.
In event of deviation, check that bulb is seated correctly in headlamp.