Remove/install fan shroud - AR20.40-P-6800AB (SL500, SL55 AMG)

ENGINE 113.963 in MODEL 230.475 

ENGINE 113.992 in MODEL 230.474 

ENGINE 112.973 in MODEL 230.467 

ENGINE 113.995 in MODEL 230.472 

Shown on model 220 with M112 

Fig 1: Identifying Fan Shroud Components - Shown On Model 220 With M112

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of injury  to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning  from swallowing coolant.	Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses.	AS20.00-Z-0001-01A
1	Drain coolant from radiator	Engines 112, 113 except engines 113.963 /992/995	AR20.00-P-1142HA
		Engines 113.963/ 992/ 995	AR20.00-P-1142RVK
2	Remove left air intake pipe to air filter
3	Unscrew bolts from retaining tabs (3) on fan shroud (1)
4	Disconnect electric plug connections for suction fan
5	Detach expansion reservoir coolant line on coolant line thermostat housing to engine radiator
6	Detach coolant line (2) at bottom right on engine radiator
7.1	Remove plate attaching ATF line	Models 215, 220 At bottom of fan shroud (arrow).
7.2	Lever off clips at top of fan shroud	Model 230
8	Remove fan shroud (1)	Pull fan shroud with retaining tabs (4) out of retaining lugs on radiator.
9	Install in the reverse order
10	Check coolant level and cooling system for leaks	Engines 112, 113 except engines 113.963 /991 /992 /995	AR20.00-P-1010HA
		Engines 113.963 /991 /992 /995	AR20.00-P-1010RVK