Keyless go control module, purpose - GF80.61-P-4102-02R

The keyless go control module (N69/5) has the following purposes:

• Control of left door keyless go lifting magnets (L12); right door keyless go lifting magnets (L12/2).
• Control of keyless go inductive antennas:
  • Rear bumper keyless go antenna (A2/31)
  • Left trunk keyless go antenna (A2/35)
  • Right trunk keyless go antenna (A2/36)
  • Left door keyless go antenna (A2/38)
  • Right door keyless go antenna (A2/40)
  • Center console keyless go antenna (A2/60)
• Locating keyless go transmitter card (A8/2) in or outside of vehicle via antenna system.
• Reading in keyless go start/stop button (S2/3).
• Reading in left door pull contact microswitch (S47s1), right door pull contact microswitch (S48s1).
• Reading in left door pressure contact (S47s2), right door pressure contact (S48s2).
• Reading in left door capacitive sensor (S47b1); right door capacitive sensor (S48b1).
• Reading in trunk lid keyless go button (S62/21).
• Reading in stop lamp switch (S9/1).