Remove/install bottom engine compartment paneling - AR61.20-P-1105SX
MODEL 216
MODEL 221 except CODE (Z07) Top protection
Shown on model 221
Fig 1: Identifying Bottom Engine Compartment Paneling Remove/Install Components - Shown On Model 221
MODIFICATION NOTES
| 8.4.09 | Tightening torque for underridge guard added | Operation step 3 |
| Remove/install | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Raise vehicle with vehicle lift | ||
| 2 | Remove front engine compartment paneling (1) | ||
| 3 | Remove center engine compartment paneling (2). | ||
| *BA61.40-P-1001-01D | |||
| 4 | Remove rear engine compartment paneling (3). | ||
| 5 | Install in the reverse order |
UNDERBODY PROTECTION
| Number | Designation | Model 221 with code (481) | Model 216 with code (481) | |
|---|---|---|---|---|
| BA61.40-P-1001-01D | Bolt, underbody protection plate | Nm | 17 | 17 |