Remove and install bottom engine compartment paneling - AR61.20-P-1105SXS
MODEL 221.1 with CODE (Z07) Top protection
| Remove/install | |||
| Risk of death caused by vehicle slipping or toppling off of the vehicle lift. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Raise vehicle with vehicle lift | ||
| 2 | Remove underbody protection plate (2) | *BA61.40-P-1001-01D | |
| 3.1 | Remove fuse 6 from fuse box I, rear right wheel well | When removing front engine compartment paneling (1) on vehicles with fire extinguishing system. | |
| Fuse and relay box, as-built configuration | GF54.15-P-0800SXS | ||
| 4.1 | Remove engine fire extinguishing system temperature sensor from front engine compartment paneling (1) and fasten to underbody with cable tie | When removing front engine compartment paneling (1) on vehicles with fire extinguishing system. | AR86.10-P-0102SXT |
| 5 | Remove front engine compartment paneling (1) | ||
| 6 | Remove rear engine compartment paneling (3) | ||
| 7 | Install in the reverse order |
UNDERBODY PROTECTION
| Number | Designation | Model 221 with code (481) | |
|---|---|---|---|
| BA61.40-P-1001-01D | Bolt, underbody protection plate | Nm | 17 |