Remove/install outer rear door handle - AR72.12-P-2410SX

MODEL 221.0 

MODEL 221.1 except CODE (Z07) Top protection 

Shown on model 221.0 with code (889) Keyless Go 

Fig 1: Identifying Outer Rear Door Handle Remove/Install Components - Shown On Model 221.0

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove outer door handle guide (1) from rear door	TORX-screwdriver, length 250 mm, T20	*BA72.12-P-1005-01M
2.1	Pull outer door handle (1) out of bearing bracket (5) toward rear and remove	On vehicles without code (889) Keyless Go Ensure that the seals (3) are seated correctly at the rear door and the outer door handle (1) in the bearing bracket (5).
2.2	Pull outer door handle (1) out of bearing bracket (5) toward rear, disconnect electrical connector (2) and remove outer door handle (1)	On vehicles with code (889) Keyless Go Arrest connection (4) of electrical connector (2) on bearing bracket (5) in assembly position Unlock connection (4) at bearing bracket (5) and press toward inside after connecting the electrical connector (2). Ensure that seals (3) are seated correctly on rear door and outer door handle (1) in bearing bracket (5)
3	Install in the reverse order