Remove/install xenon headlamp control unit - AR82.10-P-4632SXS
MODEL 221 as of 1.6.09
MODEL 221 with CODE (800) Model year 2010
Shown on the removed left lamp unit
| Remove/install | |||
| Risk of death
caused by high voltage levels present at xenon headlamps. Risk of explosion/fire hazard due to highly flammable substances in the area of damaged xenon bulbs Risk of injury due to UV light, hot components on xenon headlamps and glass splinters when xenon bulbs burst Risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming into contact with skin |
Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on xenon headlamps. Switch off entire lighting system. Wear insulated safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure sufficient ventilation in the working area. | AS82.10-Z-0001-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Temporarily store basic data for xenon headlamp control unit (E1n1 or E2n1) in STAR DIAGNOSIS | When replacing xenon headlamp control unit (E1n1 or E2n1). |
|
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A | ||
| 2.1 | Remove front section of fender liner in right front fender | When removing right xenon headlamp control unit (E2n1) on vehicles with code (487) Active Body Control (ABC). | |
| 2.2 | Remove right front lamp unit | When removing right xenon headlamp control unit (E2n1) on vehicles without code (487) Active Body Control (ABC). | AR82.10-P-4730SX |
| 3 | Remove front section of fender liner in left front fender | When removing left xenon headlamp control unit (E1n1). | |
| 4 | Remove windshield washer fluid reservoir | When removing left xenon headlamp control unit (E1n1) on vehicles with code (487) Active Body Control (ABC). | AR82.35-P-6000SY |
| 5 | Switch off ignition and withdraw transmitter key or Keyless Go start/stop button from the EIS [EZS] control unit | When removing right xenon headlamp control unit (E2n1) on vehicles without code (487) Active Body Control (ABC). | |
| 6 | Detach xenon headlamp control unit (E1n1) from bottom side of left front lamp unit (E1) or xenon headlamp control unit (E2n1) from bottom side of right front lamp unit (E2) | Figure | |
| 7 | Disconnect electrical connector and remove xenon headlamp control unit (E1n1 or E2n1) | ||
| 8 | Install in the reverse order | ||
| 9 | Check adjustment of left low beam or right low beam, correct if necessary | When replacing xenon headlamp control unit (E1n1 or E2n1). | |
| Check and correct the adjustment of the headlamps | AP82.10-P-8260SX |