Remove, install air pump - AR14.30-P-7251SX
ENGINE 272, 273 in MODEL 221
ENGINE 273 in MODEL 216
Shown on Model 221.071 with Active
Body Control (ABC) Code 487
| Remove/install | |||
| 1 | Turn key in ignition switch to position "0". | Remove Keyless Go transmitter card or transmitter key from the vehicle and store beyond transmitter range (min. 2 m). |
|
| 2 | Remove front engine cover (1) | See "Remove/install air filter housing". | AR09.10-P-1150SX |
| 3 | Remove bracket (2) for front engine cover (1) from front cover on cylinder head and from bracket (3) by removing bolts (4) | *BA14.30-P-1001-01D | |
| 4 | Remove air intake hose (5) on electric air pump (M33) | ||
| 5 | Disconnect electrical connector (6) on electric air pump (M33) | ||
| 6 | Detach bracket (3) from the cylinder head and from timing case cover by removing bolts (7) | *BA14.30-P-1002-01D | |
| 7 | Detach air hoses (8, 9) from electric air pump (M33) | ||
| 8 | Remove electrical air pump (M33) with bracket (3) | ||
| 9 | Detach electric air pump (M33) from bracket (3) | When replacing the electric air pump (M33) |
|
| *BA14.30-P-1003-01D | |||
| 10 | Install in the reverse order | ||
| 11 | Read out fault memory |
AIR PUMP
| Number | Designation | Engine 272, 273 | |
|---|---|---|---|
| BA14.30-P-1001-01D | Bracket bolt for front engine cover to bracket of electric air pump or cylinder head | Nm | 14 |
| BA14.30-P-1002-01D | Bolt, bracket for electric air pump to cylinder head or timing case cover | Nm | 14 |
| BA14.30-P-1003-01D | Bolt connecting electric air pump to bracket | Nm | 8 |