Remove/install bottom engine compartment paneling - AR61.20-P-1105M

MODEL 215, 220 Vehicles with gasoline engine 

Rear engine compartment paneling 

Fig 1: Identifying Rear Engine Compartment Paneling Screw

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Engine Fire Extinguishing System Temperature Sensor

Courtesy of MERCEDES-BENZ USA

Center engine compartment paneling 

Fig 3: Identifying Center Engine Compartment Paneling Screw

Courtesy of MERCEDES-BENZ USA

Front engine compartment paneling 

Fig 4: Identifying Front Engine Compartment Paneling

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
1	Raise vehicle with vehicle lift
2	Remove fire extinguisher system motor temperature sensor (B65) from center engine compartment paneling	Vehicles with fire extinguishing system Failure to observe can lead to actuation of fire extinguishing system!
		Model 220.1/8 up to 14.4.04 with fire extinguishing system	AR86.10-P-0102MBA
		Model 220.1/8 as of 15.4.04 with fire extinguishing system	AR86.10-P-0102MBC
3	Remove bolts (1) and remove lower engine compartment paneling	Removal sequence: rear engine compartment paneling center engine compartment paneling front right engine compartment paneling (A) front left engine compartment paneling (B). Install front right and left engine compartment paneling (A, B) so that the rubber lips are covered by the bumper.
4	Install in the reverse order