Legend of wiring diagram for heated windshield control unit - PE67.10-P-2101-60SAA
Model 221.0/1 control unit N61
| Code | Designation | Coordinates |
|---|---|---|
| A0 | Color code key | 23L |
| F32/4 | Interior prefuse box | 20L |
| M16/33 | Left B-pillar air distribution actuator motor | 4L |
| N10/1 | Front SAM control unit with fuse and relay module | 9L |
| N10/1 | Front SAM control unit with fuse and relay module | 13L |
| N61 | Heated windshield control unit | 4A |
| N61 | Heated windshield control unit | 12A |
| N61 | Heated windshield control unit | 19A |
| N82/1 | Vehicle power supply control module | 17L |
| R22/2 | Heated windshield | 2L |
| U66 | Valid for rear air conditioning | 5D |
| U900 | Further line routing not clarified at time of publication | 3E |
| U900 | Further line routing not clarified at time of publication | 5E |
| W7/1 | Ground (right tail lamp in trunk) | 15H |
| W54 | Ground (right rear wheel well) | 15H |
| X53/1 | Air conditioning connector | 3G |
| X53/1 | Air conditioning connector | 6H |
| X53/1 | Air conditioning connector | 8H |
| X53/1 | Air conditioning connector | 11H |
| X92 | Heated windshield connector | 1H |
| Z68/15 | Heated windshield LIN bus ground connector sleeve | 9F |
| Z68/16 | Heated windshield LIN bus positive connector sleeve | 8F |
| Z68/17 | Heated windshield LIN bus data connector sleeve | 4D |
| Z110/2 | AC bus solder terminal | 9J |
| Z110/2 | AC bus solder terminal | 13J |
| Z111 | Voltage supply connector sleeve | 8J |
| Z111 | Voltage supply connector sleeve | 12J |