Remove/install fog lamp - AR82.10-P-5103SX
MODEL 221.0/1
Shown on model 221 up to 31.5.09 on left front fog lamp
| Remove/install | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Raise vehicle with vehicle lift | ||
| 2 | Remove front section of fender liner in right front fender | When removing the right front fog lamp (E5/2) on vehicles without code (487) Active Body Control (ABC). | |
| 3 | Remove engine compartment paneling at front | When removing the right front fog lamp (E5/2) on vehicles with code (487) Active Body Control (ABC) or when removing the left front fog lamp (E5/1) on vehicles without code (487) Active Body Control (ABC). | |
| Vehicles without code (Z07) Top protection | AR61.20-P-1105SX | ||
| Vehicles with code (Z07) Top protection | AR61.20-P-1105SXS | ||
| 4 | Remove windshield washer fluid reservoir | When removing the left front fog lamp (E5/1) on vehicles with code (487) Active Body Control (ABC). | AR82.35-P-6000SY |
| 5 | Disconnect electrical connector (1) | ||
| 6 | Unscrew screws (2) and remove left front fog lamp (E5/1) or right front fog lamp (E5/2) from the front bumper | ||
| 7 | Install in the reverse order | ||
| 8 | Check the setting of the left front fog lamp (E5/1) or the right front fog lamp (E5/2) and correct if necessary | ||
| Check and correct the adjustment of the headlamps | AP82.10-P-8260SX |