Remove/install daylight sensor - AR82.10-P-2400I

Models 215, 220 

Shown on model 220 

Fig 1: Identifying Daylight Sensor Remove/Install Components - Shown On Model 220

Courtesy of MERCEDES-BENZ USA

MODIFICATION NOTES

11.4.03

Disconnecting ground lead from battery newly included

Step 1

	Remove/Install
1	Disconnect ground cable of battery
2	Remove overhead control panel control unit		AR82.20-P-1000M
3	Unclip covering (1)
4	Unclip covering (2)
5	Release clips (4) on left and right
6	Remove automatic light switch daylight sensor (B32/1)	Lens of automatic light switch daylight sensor (B32/1) is bonded to the windshield. Do not replace.
7	Unplug electrical connector (3) from automatic light switch daylight sensor (B32/1)
8	Install in the reverse order
9	Perform function check