Remove/install backup camera - AR54.65-P-0030SX

MODEL 216.3, 221.0/1 with CODE 218 (Rear view camera) 

Shown on model 221 

Fig 1: Identifying Backup Camera Remove/Install Components - Shown On Model 221

Courtesy of MERCEDES-BENZ USA

Shown on model 221 

Fig 2: Identifying Backup Camera Remove/Install Components - Shown On Model 221

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Remove license plate from trunk lid (1)
2	Remove umbrella holder (3)
3	Remove hazard warning triangle (5) and detach bracket (4)
4	Remove cover (6)
5	Remove hinge bracket trim pieces (2)
6	Remove trim for trunk lid (7)
7	Pull electrical connection for reversing camera (B84/3x1) out of protective sleeve (8) and detach	Position electrical connection for reversing camera (B84/3x1) with protective sleeve (8) so it does not suffer any chaffing.
8	Remove bolts (9)
9	Unclip handle strip cover (13) from inside, starting at the right-hand side of the vehicle	MODEL 221 Check adhesive tape (12). If necessary: ↓ Replace adhesive tape (12).
10	Unclip reversing camera (B84/3) from trunk lid (1)
11	Install in the reverse order
12	Calibrate backup camera (B84/3)	MODEL 216.3, 221.0 with CODE 218 (Rear view camera) with CODE 498 (Japanese version) MODEL 221.1 with CODE 218 (Rear view camera) with CODE 498 (Japanese version)	AR54.65-P-0022GZ
		MODEL 216.3 up to 5/31/07, 221.0/1 up to 5/31/07 with CODE 218 (Rear view camera) without CODE 498 (Japanese version)	AR54.65-P-0022SX