Programming of control units - AR54.21-P-0014Y
MODEL 117, 129.058/063/067/076, 156, 163, 164, 166, 168, 169, 170, 171.4, 176, 199, 203, 204, 205, 207, 208, 209, 210, 211, 212, 215, 216, 217, 218, 219, 220, 221, 222, 230, 231, 240, 242, 245 (except 245.286), 246, 251, 450.3/4, 452.3/4, 454.0
Program with XD-DVD
| Programming | |||
| 1 | Connect diagnostic system and start XD | ||
| MODEL 117, 129.058/063/067/076, 156, 163, 164, 166, 168, 169, 170, 171.4, 176, 199, 203, 204, 207, 208, 209, 210, 211, 212, 215, 216, 218, 219, 220, 221, 230, 231, 240, 242, 245 (except 245.286), 246, 251Program with XD-DVD | AD00.00-P-2000-04A | ||
| MODEL 205, 217, 222Program with XD-DVD | AD00.00-P-2000-04B | ||
| MODEL 450.3/4Program with XD-DVD | AD00.00-P-2000-04SM | ||
| MODEL 452.3/4Program with XD-DVD | AD00.00-P-2000-04RR | ||
| MODEL 454.0Program with XD-DVD | AD00.00-P-2000-04FF | ||
| 2 | Program control unit | AR54.21-P-0014-01Y | |
| 3 | Perform software calibration number (SCN) coding for control units | Only when required, refer to XD. | |
| AR54.21-P-0015X | |||
| 4 | Run teach-in procedures Only when required, refer to XD. | ||
| 5 | Read out and erase fault memory | ||
| 6 | Disconnect diagnostic system | ||
| MODEL 117, 129.058/063/067/076, 156, 163, 164, 166, 168, 169, 170, 171.4, 176, 199, 203, 204, 207, 208, 209, 210, 211, 212, 215, 216, 218, 219, 220, 221, 230, 231, 240, 242, 245 (except 245.286), 246, 251Program with XD-DVD | AD00.00-P-2000-04A | ||
| MODEL 205, 217, 222Program with XD-DVD | AD00.00-P-2000-04B | ||
| MODEL 450.3/4Program with XD-DVD | AD00.00-P-2000-04SM | ||
| MODEL 452.3/4Program with XD-DVD | AD00.00-P-2000-04RR | ||
| MODEL 454.0Program with XD-DVD | AD00.00-P-2000-04FF |