Remove/Install Load Compartment Floor - AR68.80-P-5800CY

Model 204.9 

Fig 1: Identifying Load Compartment Floor Remove/Install Components (1 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Load Compartment Floor Remove/Install Components (2 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Load Compartment Floor Remove/Install Components (3 Of 3)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove rear center section paneling (1)		AR68.30-P-4785CY
2	Remove stowage compartment cover (2)
3	Remove stowage compartment inner shelf (12)
4	Unscrew bolts (13) and remove stowage compartment (14)
5	Remove vehicle tool kit cover (3)
6	Remove first air kit cover (6)
7	Remove reservoir (8)	Vehicles without code (669) Spare tire on steel rim
8	Turn wrench (9) to side until bolt (10) is accessible
9	Unscrew bolts (10, 11) and remove vehicle tool kit (7)
10	Remove bolts (15)
11	Lift cover (16) at rear and remove from guide on front cargo area floor (17)
12	Remove left and right anchoring lugs (4)	Tighten bolts (5) with torque.
			*BA68.50-P-1001-03I
13	Lift front cargo area floor (17) in area of rear seat backrests (arrows), over consoles (18) toward rear and remove	Carefully lift front load compartment floor (17) to prevent damaging shackles (19). Ensure that shackles (19) are seated correctly in consoles (18)
14	Install in the reverse order

Cargo Retainers

Number	Designation		Model 204
BA68.50-P-1001-03I	Bolt for anchoring lug	Nm	24