Removing/Installing Rear-End Door Handle Strip - AR72.20-P-3650GZ

MODEL 164 Outer rear-end door handle strip 

Shown on model 164.1 with Keyless Go, code 889 

Fig 1: Identifying Rear-End Door Handle Strip Removing/Installing Components - Shown On Model 164.1

	Remove/install
1	Remove door lining on rear-end door		AR72.20-P-3520GZ
2	Unscrew nuts (2) from handle strip (1).	From inner side of rear-end door
3	Unscrew bolts (3) from handle strip (1).	From outer side of rear-end door
4	Disconnect electrical connector from left rear-end door license plate lamp (E19/3au) and right rear-end door license plate lamp (E19/4)
5	Remove handle strip (1)	Risk of breakage! Do not scratch paint.
6	Install in the reverse order