Replace brake hoses - AR42.10-P-0013GG

MODEL 460, 461 

MODEL 463 (except 463.270 /271) except CODE (979) Special protection version 

Illustration shows brake hose routing on front axle 

Fig 1: Identifying Brake Lines, Brake Hose, Clamp And Retaining Rubber

Courtesy of MERCEDES-BENZ USA

Illustration shows brake hose routing on rear axle with disk brakes 

Fig 2: Identifying Brake Hose And Brake Line

Courtesy of MERCEDES-BENZ USA

Illustration shows brake hose routing on rear axle with drum brakes 

Fig 3: Identifying Brake Line, Brake Hose, Retaining Spring And Retaining Rubber

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
	Risk of poisoning  caused by swallowing brake fluid. Risk of injury  caused by brake fluid coming into contact with skin and eyes.	Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid.	AS42.50-Z-0001-01A
	Risk of injury  to skin and eyes caused by handling hot or glowing objects.	Wear safety gloves, protective clothing and safety glasses, if necessary.	AS00.00-Z-0002-01A
	Brake fluid notes		AH42.50-P-0001-01A
	Notes on repairs to brake system		AH42.00-P-0003-01A
		Seal all open connections immediately using stop plugs, the brake fluid reservoir must not run empty.
1	Raise vehicle with vehicle lift
	Lift/jack up vehicle		AR00.60-P-1000G
	at front axle
2	Detach brake lines (5, 6) from brake hose (51)		Figure
			Figure
			Figure
			*BA42.10-P-1001-04B
			*BA42.10-P-1002-04B
3	Pry out clamps (52)
4	Pull brake hose (51) out of rubber holders (53)
	On rear axle with disk brakes
5	Detach brake line (2) from brake hose (1)		Figure
			Figure
			*BA42.10-P-1001-04B
6	Unscrew brake hose (1) from floating brake caliper		*BA42.10-P-1005-04B
	On rear axle with drum brakes
7	Detach upper and lower brake line (3) from brake hose (4)	Installation:  Check retaining springs (7) are correctly seated.
			Figure
			Figure
			*BA42.10-P-1001-04B
8	Pull brake hose (4) out of rubber holders (8)
9	Install in the reverse order
10	Bleed brake system		AR42.10-P-0010GG