Wiring diagram for common rail diesel injection (CDI) control unit - PE07.16-P-2101-97DAM
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 651 in MODEL 212 (except 212.098/298) Control unit N3/9, vehicle plug, Bosch
| Code: | Designation: | Position: |
|---|---|---|
| A0 | Color code key | 64L |
| B16/15 | Temperature sensor upstream of SCR catalytic converter | 55L |
| B37 | Accelerator pedal sensor | 53L |
| CAN C | Drive train CAN | 37K |
| CAN E1 | Chassis CAN 1 | 40K |
| CAN I | Drive train sensor CAN | 43K |
| Code 427 | 7-speed automatic transmission | 25E |
| Code 494 | USA version | 17H |
| Code B03 | ECO start/stop function | 28J |
| F32 | Front electrical prefuse box | 30L |
| F32f151 | Prefuse 151 | 29K |
| F32f154 | Prefuse 154 | 29K |
| M1 | Starter | 23L |
| M4/7 | Combustion engine and air conditioning with integrated control fan motor | 34L |
| N10/1 | Front SAM control unit with fuse and relay module | 5L |
| N10/1 | Front SAM control unit with fuse and relay module | 12L |
| N10/1 | Front SAM control unit with fuse and relay module | 19L |
| N10/1f22 | Fuse 22 | 3L |
| N10/1f23 | Fuse 23 | 4L |
| N10/1f24 | Fuse 24 | 14L |
| N10/1f27 | Fuse 27 | 2L |
| N10/1f6 | Fuse 6 | 7L |
| N10/1f7 | Fuse 7 | 11L |
| N118 | Fuel pump control unit | 47L |
| N2/10 | Supplemental restraint system control unit | 50L |
| N3/9 | CDI control unit | 3A |
| N3/9 | CDI control unit | 12A |
| N3/9 | CDI control unit | 36A |
| N3/9 | CDI control unit | 44A |
| N3/9 | CDI control unit | 52A |
| N3/9 | CDI control unit | 20A |
| N3/9 | CDI control unit | 28A |
| N3/9 | CDI control unit | 60A |
| U2 | Valid for all except USA | 17H |
| U240 | Valid for all except ECO start/stop function | 28H |
| U62 | Valid for 4MATIC | 56F |
| W16/6 | Right major assembly compartment ground point | 5E |
| W18 | Left front seat crossmember ground point | 44H |
| W9 | Left front ground point (at lamp unit) | 34H |
| X25/2 | Engine compartment/interior electrical connector | 8E |
| X25/2 | Engine compartment/interior electrical connector | 34E |
| X26 | Interior and engine wiring harness electrical connector | 19H |
| X30/21 | Drive train CAN voltage distributor electrical connector | 37L |
| X30/30 | Vehicle floor chassis CAN voltage distributor electrical connector | 40L |
| X30/38 | Potential distributor electrical connector (CAN I) | 43L |
| X86/1 | Nitrogen oxides control unit electrical connector | 55G |
| Y123 | Left switchable engine mount | 57L |
| Y123/1 | Right switchable engine mount | 59L |
| Y58/13 | Heat exchanger shutoff valve | 26L |
| Z3z1 | Tml. 15 connector sleeve | 6E |
| Z51/19 | Engine management crash signal connector sleeve | 50E |
| Z57/17 | Engine mount connector sleeve in engine compartment | 58G |
| Z7/35 | Circuit 87 M1e connector sleeve | 3E |
| Z7/36z1 | Circuit 87 M2e connector sleeve | 12G |
| Z7/36z1 | Circuit 87 M2e connector sleeve | 57G |
| Z7/5z1 | Circuit 87 connector sleeve | 26H |