Check setting of high beam - AP82.10-P-8260-02EW

MODEL 212, 218 with halogen headlamps 

Fig 1: Caution For Adjusting Headlamp Aimer (Model 212, 218)

Courtesy of MERCEDES-BENZ USA

The center of the light beam must be positioned on the central mark (1) in the headlamp aimer (01).

1. Check setting of high beam.

   In event of deviation, check that bulb is seated correctly in headlamp.

   Do not  make any correction to the adjustment screws for the headlamp height adjustment (H) and the adjustment screws for the headlamp side adjustment (S), as this would adjust the previously set low beam.