Prepare bottom rear center section for installation - AR64.20-P-1000-07SX

Fig 1: Identifying Bottom Rear Center Section Cross-Hatched Areas

Courtesy of MERCEDES-BENZ USA

1. Grind mating surfaces on bottom rear center section (1) down to bare metal in cross-hatched areas with round wire brush consisting of stainless steel (areas A, B, C, D, E, F, G, H, I, J, K and L).
2. Grind mating surfaces on mount below taillamp (2) down to bare metal in cross-hatched areas with round wire brush consisting of stainless steel (areas M, N, O, P, Q, R, S, T, U, V, W, X, Y and Z).

   Observe preliminary treatment of surfaces to be bonded.

   Fig 2: Identifying Grinding Surfaces On Mount Below Taillamp In Cross-Hatched Areas

   Courtesy of MERCEDES-BENZ USA