Wiper start suppression function - GF82.30-P-3008SX
MODEL 2212.0/1, 216 up to model year 8
Function requirements:
- Circuit 15R On
Wiper start suppression function
The wiper start suppression is intended to prevent the driver or front passenger from being sprayed with water from the windshield when getting in or out as the result of an initiated wipe operation.
Wipe operation is suppressed if:
- The combination switch is in position "1" or "2"
- The driver or front passenger door is open
- The speed is less than 3 km/h
- The wiper motors are in the basic position
Opening the driver or passenger-side door does not interrupt wiper operation that is currently in progress. The wipers move to the basic position.
Wiper motor actuation takes place after actuation has been suppressed if
- The combination switch is turned from position "1" or "2" to another position
- The driver and front passenger doors are closed
- The speed is faster than 3 km/h
- The gear selector switch is set to position "D" or "R".
Wiping stop function
Opening the engine hood or switching off circuit 15R immediately interrupts active wipe operation.
The wipe operation is not continued until the engine hood is closed or after switching on circuit 15R.
| Instrument cluster, component description | A1 Model 221.0/1 |
GF54.30-P-6000SX | |
| Wiper motor - Component description | M6/6 and M6/7 | GF82.30-P-5010SX | |
| Driver-side SAM control unit with fuse and relay module, component description | N10/1 | GF54.21-P-6010SX | |
| Rear SAM control unit with fuse and relay module, component description | N10/2 | GF54.21-P-6030SX | |
| Driver-side front door control unit, component description | N69/1 Model 221.0/1 |
GF72.29-P-6000SX | |
| Model 216.3 | GF72.29-P-6000SC | ||
| Passenger-side front door control unit, component description | N69/2 Model 221.0/1 |
GF72.29-P-6010SX | |
| Model 216.3 | GF72.29-P-6010SC | ||
| Electronic ignition/starter switch control unit (EIS) component description | N73 | GF80.57-P-6000SX | |
| Steering column module component description | N80 | GF54.21-P-6050SX | |
| Central gateway control unit, component description | N93 | GF54.21-P-4170SX | |
| Combination switch, component description | S4 | GF82.30-P-5000SX |