Separate Wheel Well Panel Front Section - Ar62.20-D-1280-01H

Courtesy of MERCEDES-BENZ USA

Dimensions: 

The following operation steps are shown on the left side of the vehicle on model 906.733 and must be performed analogously on the right side in the event of damage.

1. Scribe separation line on wheel well paneling front section (1) (area A).
2. Cut wheel well paneling front section (1) at separating point (area A).

   Courtesy of MERCEDES-BENZ USA

3. Expose spot welds on wheel well paneling front section (1) (areas B and C).
4. Cut out spot welds on wheel well paneling front section (1) (area B).
5. Cut out spot welds on wheel well paneling front section (1) (area C).

   Cut resistance spot welds from bottom (area C).

6. Remove damaged wheel well paneling front section (1).
7. Grind mating surfaces on wheel well paneling front section down to bare metal in crosshatched areas.

   Grind spot weld flanges down to bare metal on both sides.

8. Remove shavings and drill chips.
9. Coat insides of spot weld flanges with zinc dust paint.

   Courtesy of MERCEDES-BENZ USA