Install and weld in bottom rear center section - AR64.20-P-1000-08V
TEST AND ADJUSTMENT VALUES, GAP DIMENSIONS AT HOODS, DOORS AND COVERS
| Number | Designation | Model 171 | |||
|---|---|---|---|---|---|
| BE60.00-P-1003-01L | Gap dimension | Trunk lid to rear fender | Dimension "F" | mm | 3, 5+1, 5 |
| Trunk lid to taillamp | Dimension "M" | mm | 4.0 (+1.6/-0.5) | ||
| Rear fender to taillamp | Dimension "U" | mm | 2, 5 ± 0, 5 | ||
| See picture in | AR60.00-P-0700-01V | ||||
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation |
|---|---|
| WH58.30-Z-1003-01A | Electrode miller |
| WH58.30-Z-1003-02A | Clamping pliers |
| WH58.30-Z-1001-40A | Tarp (fire-resistant) |
WORKSHOP EQUIPMENT
| WE58.40-Z-1002-02A | Spot welder |
| WE58.40-Z-1001-05A | Two-post lifting platform |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1001-07A | Zinc dust paint suitable for spot welding | A 000 986 34 42 |
- Install rear fender, tubular frame with trunk lid, taillamps, spacers, striker eye and fit.
- Check and adjust gaps:
Rear fender to taillamp (U) Trunk lid to rear fender (F) Trunk lid to taillamp (M)
Use feeler gage.
- Fasten rear center section with clamping pliers.
- Remove tubular frame with trunk lid, taillamps, spacers and striker eye.
- Weld in rear center section (1) with
(areas A, B and C).
- Weld in rear center section (1) with
- Weld in rear center section (1) with
(area E).