Install repair bolt - AR40.20-P-0322-01IW
WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2007 Mercedes-Benz C350, 2007 Mercedes-Benz C280, 2007 Mercedes-Benz C230, 2006 Mercedes-Benz C55, and 2006 Mercedes-Benz C350. However, it is still accessible from the selected car via links, so may be relevant.
203: PROVISION FOR ADJUSTING CAMBER AND CASTER
| Lower transverse control arm front in mm | Lower transverse control arm rear in mm | Caster change | Camber change |
|---|---|---|---|
| -3 | -3 | 0' | +15' |
| -3 | 0 | +16' | -2' |
| -3 | +3 | +32' | -10' |
| 0 | -3 | -17' | +13' |
| 0 | 0 | 0 | 0 |
| 0 | +3 | +16' | -13' |
| +3 | -3 | -32' | +10' |
| +3 | 0 | -16' | -2' |
| +3 | +3 | 0 | -15' |
220: PROVISION FOR ADJUSTING CAMBER AND CASTER
| Lower transverse control arm front in mm | Lower transverse control arm rear in mm | Caster change | Camber change |
|---|---|---|---|
| -3 | -3 | 0' | +17' |
| -3 | 0 | +19' | -1' |
| -3 | +3 | +40' | -13' |
| 0 | -3 | -22' | +14' |
| 0 | 0 | 0 | 0 |
| 0 | +3 | +20' | -13' |
| +3 | -3 | -41' | +11' |
| +3 | 0 | -20' | 0 |
| +3 | +3 | 0 | -18' |
- Jack up vehicle at the front (the suspension must be fully rebounded).
- For adjusting the camber and caster the respective series production bolt (19a) on the lower transverse control arm must be replaced by a repair bolt (19c).
The repair bolt (19c) must not be twisted after fixing in position in the mount of the lower transverse control arm.
Only tighten the nuts in the ready to drive condition so that the rubber mounts of the lower transverse control arm can twist when the suspension compresses.
The repair bolt (19c) is centered by the adjusting washers (19d) in the elongated hole. The repair bolt (19c) can be installed in the right or left position by inserting the adjusting washers (19d). As a result a range of adjustment of 3 mm inwards or outwards arises at the lower transverse control arm.