Remove/install track rod and replacement of rubber mount - AR35.20-P-0112P
WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2007 Mercedes-Benz C350, 2007 Mercedes-Benz C280, 2007 Mercedes-Benz C230, 2006 Mercedes-Benz C55, and 2006 Mercedes-Benz C350. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 203, 209
| Remove/install | |||
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Replace self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| 1 | Raise vehicle with lifting platform | AR00.60-P-1000P | |
| 2 | Remove link rod (6k) | *BA32.20-P-1001-04C | |
| *BA32.20-P-1005-04C | |||
| 3 | Remove tie rod from wheel carrier | ||
| *BA35.20-P-1002-04A | |||
| Fig 2 | |||
| Fig 3 | |||
| 4 | Mark installation position of eccentric disk relative to the rear axle carrier (arrow) | ||
| 5 | Remove bolt (4a) and remove tie rod (4) | *BA35.20-P-1001-04A | |
| Checking | |||
| 6 | Check rubber mount (4b) for damage, replace rubber mount (4b) if necessary | AR35.20-P-0112-01P | |
| 7 | Install in the reverse order | ||
| 8 | Perform chassis alignment | AR40.20-P-0200P |
| Number | Designation | Model 203 | Model 209 | ||
|---|---|---|---|---|---|
| BA35.20-P-1001-04A | Self-locking nut, track rod to rear axle carrier | Stage 1 | Nm | 70 | 50 |
| Stage 2 | ∠ ° | - | 45 | ||
| BA35.20-P-1002-04A | Self-locking nut, tie rod to wheel carrier | yellow M10x1 | Nm | - | - |
| silver or blue M10x1 | Nm | - | - | ||
| silver or blue M10x1.5 | Nm | 30 | 30 | ||
| Number | Designation | Model 203 | Model 209 | |
|---|---|---|---|---|
| BA32.20-P-1001-04C | Nut for attaching link rod to torsion bar | Nm | 40 | 40 |
| BA32.20-P-1005-04C | Bolt, link rod to wheel carrier | Nm | 40 | 50 |