LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2011 >> SLK300 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Electrical System - Engine -- 203 Chassis) >> Testing & Repair >> Remove/install camshaft Hall sensor - AR15.10-P-2000QB

Remove/install camshaft Hall sensor - AR15.10-P-2000QB

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2007 Mercedes-Benz C350, 2007 Mercedes-Benz C280, 2007 Mercedes-Benz C230, 2006 Mercedes-Benz C55, and 2006 Mercedes-Benz C350. However, it is still accessible from the selected car via links, so may be relevant.

ENGINE 272.920 in MODELS 203.052 /252 /752 

ENGINE 272.940 in MODELS 203.054 /254, 209.354 /454 

ENGINE 272.960 in MODELS 203.056 /256 /756, 209.356 /456 

ENGINE 272.970 in MODELS 203.087 /287 

ENGINE 272.941 in MODELS 203.092 /292 

ENGINE 273 in MODEL 209 

Fig 1: Identifying Camshaft Hall Sensor Remove/Install Components - Engine 272.920/940/941
G04734075
REMOVINGINSTALLING Remove/install    
DANGER Risk of injury  caused by fingers being pinched or crushed  when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof. Keep body parts and limbs well clear of moving parts. AS00.00-Z-0011-01A
1 Open engine hood and raise to vertical position Model 203 AR88.40-P-1000P
    Model 209 AR88.40-P-1000Q
2 Remove front engine cover (1) IMPORTANT Pull out the front engine cover (1) from the mounts.  
3 Remove left or right suction fan duct (2)    
4 Disconnect plug from respective exhaust camshaft Hall sensor    
5 Unscrew bolt (3) and pull respective camshaft
Hall sensor out of front cover on cylinder head
IMPORTANTInstallation:  Replace sealing ring.  
    TORQUE SPECIFICATION *BA15.10-P-1002-03E 
    SPECIAL TOOL External Torx set Fig 2
6 Install in the reverse order    
7 Read out fault memory STAR DIAGNOSIS diagnosis system *WH58.30-Z-1048-13A 
REFER TO SELF-DIAGNOSTIC SYSTEMS Connect STAR DIAGNOSIS and read out fault memory   AD00.00-P-2000-04A
DANGER Risk of accident  caused by vehicle starting off by itself when engine is running. Risk of injury  caused by contusions and burns during starting procedure or when working near the running engine Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not grasp hot or rotating parts.
AS00.00-Z-0005-01A
8 Run engine and inspect for oil leaks    
TORQUE SPECIFICATION POSITION SENSOR

Number Designation Engine 272 Engine 273
BA15.10-P-1002-03E Bolt, camshaft Hall sensor to front cover on cylinder head Nm 8 8
Fig 2: Identifying External Torx Set (001 589 76 09 00)
G04734076
COMMERCIALLY AVAILABLE TOOLS

Number Designation
WH58.30-Z-1048-13A STAR DIAGNOSIS diagnosis system, Compact Passenger Car 6511 1801 00