Parking brake - adjusting cable slack adjuster - AP42.20-P-4262R
MODELS 230, 240
Shown on model 230
MODIFICATION NOTES
| 6.3.03 | Check version of parking brake pedal assembly, incorporated for the first time | Step 1 | BT42.20-P-0510-01A |
| Inspect | |||
|---|---|---|---|
| Risk of death. Death may result if vehicle slips or topples from the lifting platform. | Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Check version of parking brake pedal assembly | See ↓ | |
| Parking brake pedal assembly modified | BT42.20-P-0510-01A | ||
| 2 | Operate parking brake pedal and check pedal travel of parking brake pedal | ||
| Control force on parking brake pedal | *BE42.20-P-1001-01C | ||
| Number of notches that parking brake pedal has to be pressed | *BE42.20-P-1002-01C | ||
| 3 | Raise vehicle with lifting platform wheel-free | ||
| 4 | Correct lengthening of parking brake cables (85, 86) | ||
| 5 | Check that the rear wheels can turn freely |
ADJUSTING VALUES FOR PARKING BRAKE
| Number | Designation | Model 230, pedal assembly with pulled detent | Model 230, Pedal assembly with pushed notch | |
|---|---|---|---|---|
| BE42.20-P-1001-01C | Control force on parking brake pedal | N | 170 (-50/+70) | 170 (-50/+70) |
| BE42.20-P-1002-01C | Number of notches that parking brake pedal has to be pressed | Quantity | 1 | 5 |
| See fig. | BT42.20-P-0510-01A | BT42.20-P-0510-01A | ||
ADJUSTING VALUES FOR PARKING BRAKE
| Number | Designation | Model 240, pedal assembly with pulled detent | Model 240, pedal assembly with pushed detent | |
|---|---|---|---|---|
| BE42.20-P-1001-01C | Control force on parking brake pedal | N | 170 (-50/+70) | 170 (-50/+70) |
| BE42.20-P-1002-01C | Number of notches that parking brake pedal has to be pressed | Quantity | 1 | 5 |
| See fig. | BT42.20-P-0510-01A | BT42.20-P-0510-01A | ||