Remove/install paneling on upper windshield - AR68.30-P-4250R
MODEL 230.4
Shown on model 230.4 without CODE (P99) "AMG Black Series" special model
| Remove/install | |||
|---|---|---|---|
| 1 | Open Vario roof completely | On vehicles without code (P99) "AMG Black Series" special model | |
| 2 | Remove left and right paneling from A-pillar | AR68.30-P-4050R | |
| 3 | Remove overhead control panel control unit | AR82.20-P-1000R | |
| 4 | Remove inside rearview mirror | AR68.40-P-0001R | |
| 5 | Disconnect electrical connector on rain sensor (B38) or rain/light sensor (B38/2) | ||
| 6 | Disconnect electrical connector on automatic light switch daylight sensor (B32/1) | Up to 14.1.04 | |
| 7 | Remove left and right sun visor | AR68.60-P-5480R | |
| 8 | Unclip left vanity mirror illumination (E14/6) and right vanity mirror illumination (E14/7) | ||
| 9 | Disconnect electrical connectors (2) from left vanity mirror illumination (E14/6) and right vanity mirror illumination (E14/7) and remove left vanity mirror illumination (E14/6) as well as right vanity mirror illumination (E14/7) | ||
| 10 | Remove paneling (1) toward rear from windshield frame. | On vehicles without code (P99) "AMG Black Series" lift rubber lip (arrow) with long wedge (6) over paneling (1). |
|
| Fig 2 | |||
| 11 | Detach wiring harness (5) | ||
| 12 | Install in the reverse sequence |