Remove/install washer fluid reservoir of windshield washer system - AR82.35-P-6000RBS (Black Series)

MODEL 230.4 with CODE (P99) "AMG Black Series" special model 

Fig 1: Removing/Installing Washer Fluid Reservoir Of Windshield Washer System - Black Series

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Unhook trunk partition
2	Remove trunk floor
3	Remove stowage box/tray for vehicle tool kit
4	Pull out windshield washer fluid pump (M5/1) and HCS (SRA) pump (M5/2) complete with hoses and electrical connections upward and out of washer fluid reservoir (1)	Collect washer fluid which flows out. Installation:  Check rubber grommets on windshield washer fluid pump (M5/1) and HCS (SRA) pump (M5/2), replace if necessary.
5	Disconnect electrical connector at the switch of the windshield washer system fluid level control (S42)
6	Detach windshield washer fluid level indicator switch (S42)	When replacing the washer fluid reservoir (1). Installation: Inspect gasket, install new part if necessary.
7	Unscrew nut (3)
8	Unclip washer fluid reservoir (1) from bracket (2) (arrow A) and remove it		Fig 2
9	Install in the reverse order
10	Fill washer fluid reservoir (1)		AP82.35-P-8210N

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA