No audio for a few seconds after engine is started - AF82.85-P-1006A

MODEL 203, 209, 215, 220, 230, 463 with CODE (803) Model year 2003 with D2B fully equipped

OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES

Category	Op. no.	Operation text	Time	Acc. no.	Code
P	023800	Remove install Teleaid control unit, replace if necessary, MODEL 215, 220	012 WU	-	-
P	829621	Remove install Teleaid control unit, replace if necessary, MODEL 203, 209	008 WU	-	-
G	829621	Remove install Teleaid control unit, replace if necessary, MODEL 463,	009 WU	-	-
P	829622	Replace audio gateway control unit (after testing), MODEL 2300	23 WU	-	-

Damage code	Cause	Remedy
82 876 52	Run time problem in the D2B ring.	Emergency call operation is still possible. Only the MB Info service is not available.
	Within the first 5 minutes after the engine has been started, the audio is muted for 2-3 seconds.	1 Remove TELE AID control unit.
	This fault only occurs on vehicles that are equipped with a complete dealer kit (voice control system and cell phone).	Bridge D2B ring: ↓
		2 Disconnect D2B connector from the E-Call control unit.
		3 Open plug housing.
		4 Connect both fiber optical cables with the connector (A 000 545 33 84).
		5 Install TELE AID control unit.

PARTS ORDERING NOTES

Part no.	Designation	Quantity
A 000 545 33 84	Connector	as required