Remove/install fiber optic cable - AR82.70-P-0004RA: Notes

MODEL 230.475 1# up to 14.1.04 with CODE (810) Sound system with CODE (819) CD changer 

Removal of fiber optic cable between COMAND/radio and luggage box in left rear 

Removal of fiber optic cable M1 

Fig 1: Identifying Fiber Optic Cable M1 Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Switch TELE AID to Service mode	With CODE (855) TELE AID. This ensures that the additional battery is not discharged and no emergency call signal is transmitted, refer to owner's manual.
	Notes on fiber optic		AH82.70-P-0001-02A
	Risk of explosion  caused by oxyhydrogen gas. Risk of poisoning and caustic  burns caused by swallowing battery acid. Risk of injury  through burns to skin and eyes from battery acid or when handling damaged lead-acid batteries	No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and safety glasses. Pour battery acid only into suitable and appropriately marked containers.	AS54.10-Z-0001-01A
2	Disconnect ground lead from vehicle electrical system battery in trunk and disconnect starter battery in engine compartment	First vehicle electrical system battery and then starter battery.	AR54.10-P-0003R
	Notes on battery	All models	AH54.10-P-0001-01A
3.1	Remove radio	With code 750a or 750b.	AR82.60-P-7502R
3.2	Remove/install operating, display and control unit	With code 352a.	AR82.85-P-7472R
4	Remove center armrest	Remove/install stowage box	AR68.20-P-2320R
5	Remove left rear luggage box		AR68.30-P-7440R
6	Cover fiber optic cable	Do not kink or stretch D2B fiber optic cable. Install covers on fiber optic cable and equipment connectors.	AR82.95-P-0005-01A
7	Decommission fiber optic cable module		AR82.70-P-0004-01A
8	Install in the reverse sequence
9	Carry out start-up and function test