Notes on application of sealant to oil pan - AH01.45-P-0001-01AMG

Application off sealant to oil pan top section on an engine with a front sump

The line (1) identifies the sealant run

The sealing surface must be cleaned.

The sealing compound must only be applied to the specified surface in the form of a bead and a height and width of 2.0 mm (±0.5 mm).

The sealing compound must be applied within 10 min.

The sealant bead must not be spread. Only the sealing compound listed in the Repair Products may be used.

Fig 1: Identifying Sealant Application Areas On Oil Pan Top Section On Engine With Front Sump

Courtesy of MERCEDES-BENZ USA

Application off sealant to oil pan bottom section on an engine with a front sump

The line (1) identifies the sealant run

The sealing surface must be cleaned.

The sealing compound must only be applied to the specified surface in the form of a bead and a height and width of 2.0 mm (±0.5 mm).

The sealing compound must be applied within 10 min.

The sealant bead must not be spread. Only the sealing compound listed in the Repair Products may be used.

Fig 2: Identifying Sealant Application Areas On Oil Pan Bottom Section On An Engine With Front Sump

Courtesy of MERCEDES-BENZ USA

Application off sealant to oil pan top section on an engine with a rear sump

The line (1) identifies the sealant run

The sealing surface must be cleaned.

The sealing compound must only be applied to the specified surface in the form of a bead and a height and width of 2.0 mm (±0.5 mm).

The sealing compound must be applied within 10 min.

The sealant bead must not be spread. Only the sealing compound listed in the Repair Products may be used.

Fig 3: Identifying Sealant Application Areas On Oil Pan Top Section On Engine With Rear Sump

Courtesy of MERCEDES-BENZ USA

Application of sealant to oil pan bottom section at rear for engine with rear sump

The line (1) identifies the sealant run

The sealing surface must be cleaned. The sealing compound must only be applied to the specified surface in the form of a bead and a height and width of 2.0 mm (±0.5 mm).

The sealing compound must be applied within 10 min.

The sealant bead must not be spread. Only the sealing compound listed in the Repair Products may be used.

Fig 4: Identifying Sealant Application Areas On Oil Pan Bottom Section At Rear For Engine With Rear Sump

Courtesy of MERCEDES-BENZ USA

Application of sealant to oil pan bottom section at front for engine with rear sump

The line (1) identifies the sealant run

The sealing surface must be cleaned. The sealing compound must only be applied to the specified surface in the form of a bead and a height and width of 2.0 mm (±0.5 mm).

The sealing compound must be applied within 10 min.

The sealant bead must not be spread. Only the sealing compound listed in the Repair Products may be used.

Fig 5: Identifying Sealant Application Areas On Oil Pan Bottom Section At Front For Engine With Rear Sump

Courtesy of MERCEDES-BENZ USA