Gap dimensions - BE60.00-P-1000-01R
Model 221
CHECK VALUES FOR GAPS
| Number | Designation | Model 221 | |||
|---|---|---|---|---|---|
| BE60.00-P-1001-01R | Gap dimension | Engine hood to fender | Dimension "A" | mm | 3.5 (±0.5) |
| Engine hood to headlamp | Dimension "B" | mm | 3.5 (±0.5) | ||
| Radiator grille/bumper | Dimension "C" | mm | 5 (±1) | ||
| Engine hood to bumper | Dimension "P" | mm | 5 (±1.5) | ||
| Bumper to headlamp | Dimension "Q" | mm | 3.5 (±0.5) | ||
| Bumper to fender | Dimension "R" | mm | 3.5 (±0.5) | ||
| See picture | AR60.00-P-0700-01S X | ||||
| BE60.00-P-1002-01R | Gap dimension | Front door to A-pillar | Dimension "D" | mm | 4.5 (±0.5) |
| Front door to fender | Dimension "E" | mm | 4 (±0.5) | ||
| Front door to rear door | Dimension "F" | mm | 4.5 (±0.5) | ||
| Trim strip at front door to roof frame | Dimension "G" | mm | 4.5 (±40.5) | ||
| Trim strip at rear door to roof frame | Dimension "H" | mm | 4.5 (±40.5) | ||
| Rear door to side section, bottom | Dimension "I" | mm | 4.5 (±40.5) | ||
| Front door cover to rear door cover | Dimension "S" | mm | 4.5 (±40.5) | ||
| See picture | AR60.00-P-0700-01S X | ||||
| BE60.00-P-1003-01R | Gap dimension | Trunk lid to rear fender, top | Dimension "J" | mm | 4 (±0.5) |
| Trunk lid to rear lamp unit | Dimension "K" | mm | 4 (±0.5) | ||
| Trunk lid to bumper | Dimension "L" | mm | 5.5 (±1.5) | ||
| Rear fender to rear lamp unit | Dimension "M" | mm | 2.5 (±0.5) | ||
| Trunk lid license plate panel to rear lamp unit | Dimension "N" | mm | 4 (±0.5) | ||
| See picture | AR60.00-P-0700-01S X | ||||
| BE60.00-P-1004-01R | Gap dimension | Fuel filler flap | Dimension "O" | mm | 3.5 (±0.5) |
| See picture | AR60.00-P-0700-01SX | ||||
| BE60.00-P-1005-01R | Gap dimension | Center door to front door | Dimension "T" | mm | 4.5 (±0.5) |
| Center door to rear door | Dimension "U" | mm | 4.5 (±0.5) | ||
| Trim strip of center door to roof frame | Dimension "V" | mm | 4.5 (±0.5) | ||
| See picture | - | ||||