Remove/install front axle level sensors - AR82.10-P-0004GZ

MODEL 164 

Fig 1: Identifying Front Level Sensor, Electrical Connector, Connecting Arm, Bracket And Nut

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1	Raise vehicle with lifting platform		AR00.60-P-1000GZ
2	Turn key in ignition switch to position "0".	On vehicles with Keyless Go, code 889: Press keyless go start/stop button repeatedly until ignition is switched off
3	Disconnect electrical connector (1)
4	Remove connecting arm (2) from left front level sensor (B22/8) or right front level sensor (B22/9)
5	Unscrew nuts (3) for bracket (4)	Installation:  Replace self-locking nuts (3).
			BA82.10-P-1001-01B
	Notes on self-locking nuts and bolts	All models	AH00.00-N-0001-01A
6	Remove left front level sensor (B22/8) or right front level sensor (B22/9) with bracket (4)
7	Remove screws from bracket (4) and remove left front level sensor (B22/8) or right front level sensor (B22/9)		*BA82.10-P-1002-01B
8	Install in the reverse order
	Checking
9	Adjust the zero position of the xenon headlamps
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-P-2000-04A
		STAR DIAGNOSIS diagnosis system	*WH58.30-Z-1048-13A

FRONT AXLE LEVEL SENSOR

Number	Designation		Model 164.1/8
BA82.10-P-1001-01B	Nut for sensor with bracket to "console for upper transverse control arm"	Nm	8
BA82.10-P-1002-01B	Bolt/nut of level sensor to retaining plate	Nm	4

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1048-13A	STAR DIAGNOSIS diagnosis system, Compact Passenger Car	6511 1801 00