Remove/install ashtray housing in front center console - AR68.20-P-2400GZ

MODEL 164 

Fig 1: Identifying Front Center Console Ashtray Housing Remove/Install Components (1 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Front Center Console Ashtray Housing Remove/Install Components (2 Of 3)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Front Center Console Ashtray Housing Remove/Install Components (3 Of 3)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Switch off ignition and remove transmitter key from EIS control unit	On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until the ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m).
2	Open ashtray housing (1)
3	Lift paneling (2) (arrows)
4	Close ashtray housing (1)
5	Remove bolt (3)
6	Remove lower control panel control unit	Do not disconnect electrically	AR54.21-P-1263GZ
7	Slide ashtray housing (1) toward rear
8	Turn ashtray housing (1) and disconnect electrical connector (4)
9	Remove ashtray housing (1)
10	Install in the reverse order