| |
Calibrate backup camera |
|
| 1 |
Drive the vehicle onto a level surface and place the front wheels in the straight-ahead position |
The suspension level must be on drive mode drive mode. |
| |
Passenger-side outside mirror backup camera |
|
| 2 |
Align calibrating template (1) parallel and centrally with the vehicle as per the dimensions A and B (parallel to the front axle) on the floor |
If necessary, fabricate the calibrating template (1) as per the dimensions (C and D) e.g. from wood or carton material) and provide with contrast strips. Calibration template width 60 mm. |
| 3 |
Close trunk lid and front passenger door |
Bring front passenger mirror into the drive mode. |
| 4 |
Place ignition on position "2" |
|
| 5 |
Calibrate reversing camera using diagnostic system |
Instructions under menu item "backup camera control unit". |
| |
Trunk lid reversing camera |
|
| 6 |
Align the calibration template (2) parallel and centrally to the vehicle on the floor as per dimension B |
If necessary fabricate the calibration template (2) as per the dimension E (e.g out of wood or cardboard packaging) and provide with contrast strips. Calibrating template width 100 mm |
| 7 |
Close trunk lid and front passenger door |
|
| 8 |
Place ignition on position "2" |
|
| 9 |
Calibrate reversing camera using diagnostic system |
Instructions under menu item "backup camera control unit". |