Remove/install vacuum pump - AR43.05-P-1320GZ
MODEL 164 with ENGINE 642
| Remove/install | |||
|---|---|---|---|
| 1 | Removes strut tower brace | Model 164.8 only Remove strut tower brace from strut tower mounts. |
AR62.30-P-2500GY |
| 2 | Remove engine trim panel | Installation: Ignition switched off. | AR01.10-P-2405GZB |
| 3 | Press in fastening catches on vacuum line (3) and pull off. | ||
| 4 | Loosen bolts (2) at noise muffler (1). | Installation: Check sealing ring at noise muffler (1) for damage and apply light coating of grease. | |
| *BA43.05-P-1003-01A | |||
| 5 | Remove noise muffler (1). | Seal opening at throttle valve actuator. | |
| 6 | Loosen bolts (5) of vacuum pump (4). | Installation:
Position driver of vacuum pump (4) correctly in camshaft. Installation: Ensure seal is seated correctly at cylinder head. Installation: Replace factory-installed aluminum screw/bolts installed with steel screw/bolts. |
|
| *BA43.05-P-1001-01A | |||
| Loctite 243 | *BR00.45-Z-1133-02A | ||
| 7 | Remove vacuum pump (4). | ||
| 8 | Install in the reverse order |
VACUUM PUMP
| Number | Designation | Model 164 with engine 642 | |
|---|---|---|---|
| BA43.05-P-1001-01A | Bolt, vacuum pump to cylinder head | Nm | 9 |
| BA43.05-P-1003-01A | Bolt, noise muffler | Nm | 9 |
REPAIR MATERIALS
| Number | Designation | Order number | ||
|---|---|---|---|---|
| BR00.45-Z-1133-02A | Loctite 243 | A 613 989 09 71 | ||