Install and weld in outer rear center section - AR64.20-P-1000-10GZ

Measures for preventing damage to vehicles or components when performing arc welding work

All models

AH00.00-N-0005-01A

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1003-02A	Clamping pliers
WH58.30-Z-1001-03A	Round wire brush, braided, dia. 70 mm

WORKSHOP EQUIPMENT

WE58.40-Z-1002-02A	Spot welder
WE58.40-Z-1001-03A	Drill (electric/pneumatic)
WE58.40-Z-1005-03A	Wet/dry vacuum cleaner
WE58.40-Z-1003-14A	Blind rivet tool

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1001-13A	Rivet	A 003 990 35 97

1. Fit outer rear center section and fasten with clamping pliers.
2. Weld in outer rear center section in areas C and D with .
3. Mark holes for rivet connection in area A, bore and deburr

   Dia. 6.5 mm drill bit.

4. Rivet outer rear center section in area A.
5. Clean welds.
6. Remove drilling chips with wet/dry vacuum cleaner.
   Fig 1: Identifying Weld In Outer Rear Center Section Shaded Areas A To D

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.