Remove/install display in rear - AR82.60-P-7720GZ

MODEL 164, 251 with CODE (864) Rear entertainment system 

Shown on model 164.8 

Fig 1: Identifying Rear Display

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Rear Display Components Location (1 Of 2)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: Identifying Rear Display Components Location (2 Of 2)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
1	Turn key in ignition switch to position "0".	On vehicles with Keyless Go, code 889: Press keyless go start/stop button repeatedly until ignition is switched off
2	Remove front seat head restraint	Model 164 with electrically adjustable head restraint.	AR91.16-P-0040GZ
		Model 164 with mechanically adjustable head restraint.	AR91.16-P-0040GZA
		Model 251.	AR91.16-P-0040RT
3	Unclip cover (2)	Unclip at bottom left and right (arrows A).
4	Detach clamping plates (3)
5	Separate electrical connectors (4)
6	Unclip cover (5)	Unclip at bottom left and right (arrows B).
7	Loosen bolts (7)	Do not remove completely.
8	Pull monitor frame unit (6) out upwards	Pay attention to electrical lines, risk of breakage!
9	Unclip clips (8)
10	Remove bolts (9)
11	Remove bracket (10)
12	Pull out pin (11)
13	Remove locking pin (12)
14	Remove left rear display (A40/5) or right rear display (A40/6) from monitor frame (1)
15	Install in the reverse order