Backup camera control unit component description - GF54.65-P-5030GMJ
MODEL 164.1 as of Model Year 09/Modification year 08 Model refinement package with CODE (218) Backup camera with CODE (498) Japan version
MODEL 164.8, 251.0 as of Model Year 09/Modification year 08 with CODE (218) Backup camera with CODE (498) Japan version
Shown on model 164.1
Location
The reversing camera control unit is fitted under the left front seat.
Illustrated on model 251.0
Location
The reversing camera control unit is fitted on a bracket under the left front seat.
Task
The reversing camera control unit has the following tasks:
- Reading in of signals
- Evaluation of input factors
- Actuation of components
Reading in of signals
The input factors are read in with the following connections:
- Interior CAN
- Direct line
Interior CAN
The following signals are read in with interior CAN by the:
by the central gateway control unit (N93):
- Steering wheel angle sensor (N49) above the steering column tube module (N80)
- Intelligent servo module for DIRECT SELECT (A80)
From the rear SAM control unit (N10/8):
- Rear-end door locking unit, status) A72
by the instrument cluster (A1):
- Vehicle speed signal
by the EZS control unit (N73)
- Circuit status
Direct line
- Reversing camera (B84/3)
- Passenger-side outside mirror reversing camera (B84/6)
Evaluation of input factors
The input factors that have been read in are evaluated by the integrated microprocessor and the relevant components are then actuated.
Actuation of components
Components are actuated with the following lines:
- Direct line
Direct line
The following components are actuated via a direct line:
- Backup camera
- Passenger-side outside mirror backup camera
- COMAND operating, display and control unit (A40/3)
| Wiring diagram for backup camera control unit | Model 164 | PE54.65-P-2102-99MAB | |
| Model 251 | PE54.65-P-2102-99RAB |