Remove/install front prefuse box - AR54.15-P-1330GZ
MODEL 164
Shown on model 164.1 with engine 272
| Remove/install | |||
| Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices | No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers. |
AS54.10-Z-0001-01A | |
| 1 | Disconnect battery ground cable | AR54.10-P-0003GZ | |
| Notes on battery | All models | AH54.10-P-0001-01A | |
| Notes on AGM battery | AH54.10-P-0002-01A | ||
| 2 | Open engine hood and raise to vertical position | AR88.40-P-1000GZ | |
| 3 | Remove plastic sleeve (1) for nut (2) | ||
| 4 | Unscrew nut (2) and remove positive line, circuit 30 (3) | ||
| 5 | Detach front prefuse box (F32) from engine compartment | ||
| 6 | Detach cover (4) from front prefuse box (F32) | ||
| 7 | Unscrew nuts (5) and lines, remove circuit 30 (6) | ||
| 8 | Remove front prefuse box (F32) | ||
| 9 | Install in the reverse order | ||
| 10 | Perform basic programming | AR00.19-P-0200GZ |