Remove/install backup camera control unit - AR54.65-P-0025GZ

MODEL 164 with CODE (218) Backup camera with CODE (498) Japan version 

Fig 1: Identifying Backup Camera Control Unit Remove/Install Components - Shown On Model 164.1

Courtesy of MERCEDES-BENZ USA

Shown on model 164.1 

	Remove/install
	Notes on avoiding damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Switch off ignition and remove transmitter key from EIS control unit	On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until the ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m).
2	Remove left front seat		AR91.10-P-1000GZ
3	Remove door sill molding on front left and rear left		AR68.30-P-4100GZ
4	Remove lower trim on the left B-pillar		AR68.30-P-4700GZ
5	Remove cover (2).
6	Remove load retainers (3)		*BA68.50-P-1001-03F
7	Fold back rear floor covering (1) on the left until the clip (4) and nuts (6) are accessible
8	Remove clip (4) and remove air duct (5)
9	Remove nuts (6) and remove left intermediate bottom (7)
10	Separate electrical connectors (8) from the backup camera control unit (N66/2)
11	Unscrew nut (9) and remove bracket (10)
12	Unscrew nuts (11) and remove backup camera control unit (N66/2) from bracket (10)
13	Install in the reverse order
14	Calibrate backup camera control unit (N66/2)	When replacing the backup camera control unit (N66/2)	AR54.65-P-0022GZ
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-P-2000-04A
		STAR DIAGNOSIS diagnosis system	*WH58.30-Z-1048-13A