PARKTRONIC control unit component description - GF54.65-P-5001GMA

MODEL 164.1 as of model year 09/Year of Modification 08 model refinement package with CODE (220) PARKTRONIC 

Location 

The PTS control unit is located below the driver seat.

Task 

The PTS control unit has the following tasks:

• Reading in of sensors and signals 
• Evaluation of input factors 
• Actuation of components 

Reading in of sensors and signals 

The input factors are read in with the following connections:

• Direct line 
• Interior CAN 

Direct line 

The following signals and sensors are read via a direct line:

• Circuit 30
• Tml. 31
• Outer left front PTS ultrasonic sensor (B8/1)
• Center left front PTS ultrasonic sensor (B8/2)
• Inner left front PTS ultrasonic sensor (B8/3)
• Inner right front PTS ultrasonic sensor (B8/4)
• Center right front PTS ultrasonic sensor (B8/5)
• Outer right front PTS ultrasonic sensor (B8/6)
• Outer right rear PTS ultrasonic sensor (B8/7)
• Inner right rear PTS ultrasonic sensor (B8/8)
• Inner left rear PTS ultrasonic sensor (B8/9)
• Outer left rear PTS ultrasonic sensor (B8/10)

Interior CAN 

The following signals are read in with interior CAN by the:

by the instrument cluster (A1):

• Vehicle speed
• Status of PARKTRONIC

  (model 164 with code (430) Offroad package)

From the front SAM control unit (N10):

• Status of foot-operated parking brake

By the overhead control panel control unit (N70):

• Signal "Day" or "Night"

From the upper control panel control unit (N72/1):

• PTS OFF switch (N72/1s8)

  (model 164 without code (430) Offroad package, model 251)

by the EZS control unit (N73)

• Status of circuit 15R

by the central gateway control unit (N93):

• Wheel speeds and wheel rotation direction
• Status of reverse gear
• Drive position

From the rear SAM control unit (N10/8)

• Trailer recognition

  (with code (550) Trailer hitch)

Evaluation of input factors 

The input factors that have been read in are evaluated by the integrated microprocessor and the relevant components are then actuated.

Actuation of components 

Components are actuated with the following lines:

• Direct line 
• Interior CAN 

Direct line 

The following components are actuated via a direct line:

• PTS warning indicator, driver side dashboard (A44/1)
• Rear dome lamp PTS warning indicator (A44/3)
• PTS ultrasonic sensors

Interior CAN 

The following signal is transmitted via interior CAN:

To upper control panel control unit:

• Status of PARKTRONIC for actuating the light-ewithting diode integrated in the PTS OFF switch (without code (430) Offroad package)

for the instrument cluster:

• Status of PARKTRONIC

  (with code (430) Offroad package)

• Warning issue

Wiring diagram for Parktronic system (PTS) control unit

PE54.65-P-2101-99MAB