Retrofit illuminated door sill molding - AZ82.20-P-0001GZA

MODEL 164.1## 1# with CODE (800) Model year 2010 with CODE (801) Model year 2011 

MODEL 164.8## 1# with CODE (800) Model year 2010 with CODE (801) Model year 2011 with CODE (802) Model year 2012 

Fig 1: Identifying Illuminated Door Sill

Courtesy of MERCEDES-BENZ USA

	Remove
	Notes on avoiding damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Move back driver seat and front passenger seat
2	Remove door sill moldings		AR68.30-P-4100GZ
3	Remove B-pillar paneling at bottom	Only release right trim at top of B-pillar.	AR68.30-P-4700GZ
4	Move driver seat and front passenger seat forward
5	Fold down right and left rear seat cushion
6	Fold up cover below rear seat cushion
	Install
7	Install actuation module		AZ82.20-P-0001-05GZA
8	Retrofit illuminated door sill molding wiring harness		AZ82.20-P-0001-04GZA
		Wiring harness repair kit, basic	Fig 2
		New passenger car wiring harness repair kit	Fig 3
9	Install B-pillar paneling at bottom		AR68.30-P-4700GZ
10	Fasten left and right front edge guard
11	Retrofit illuminated door sill moldings (2)		AZ82.20-P-0001-01GZA
12	Install remaining parts
13	Perform function check on illuminated door sill moldings (2)	Opening the respective doors activates the illuminated door sill moldings (2).
14	Remove protective foil from illuminated door sill moldings (2)
15	Document retrofitted equipment via vehicle documentation (VeDoc)	Attach "Illuminated door sill moldings retrofitted as per AZ82.20-P-0001GZA " note under field organization texts to design group 82.

Fig 2: Identifying Wiring Harness Repair Kit, Basic (000 589 13 99 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Passenger Vehicle Wiring Harness Repair Kit (220 589 04 99 00)

Courtesy of MERCEDES-BENZ USA