Retrofit illuminated door sill molding - AZ82.20-P-0001GX

MODEL 164.8## 1# up to 30.6.09 except CODE (800) Model year 2010 installation of door sill, 2-fold 

AMG design 

Fig 1: Identifying Illuminated Door Sill (AMG Design)

Courtesy of MERCEDES-BENZ USA

Mercedes-Benz design 

Fig 2: Identifying Illuminated Door Sill (Mercedes-Benz Design)

Courtesy of MERCEDES-BENZ USA

	Remove
	Risk of death  caused by contact with parts conducting high voltages.	Do not come into contact with parts that are under high voltage. Persons who wear electronic implants (e.g. heart pacemakers) must not carry out any work on such components.	AS00.00-Z-0020-01A
	Notes on avoiding damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Remove door sill molding	Door sill moldings at left and right front and left and right rear.	AR68.30-P-4100GZ
2	Remove paneling in left and right footwell		AR68.30-P-4010GZ
3	Remove paneling on left and right B-pillar	Do not remove the seat belt from the front seat.	AR68.30-P-4700GZ
4	Remove lining on the right-hand side of the trunk		AR68.30-P-4800RT
5	Detach rear fuse and relay box	Do not disconnect electrical connectors.	AR54.15-P-1261GZ
6	Remove bass module speaker	On vehicles with code (810) Sound system	AR82.62-P-7839GZ
7	Remove coverings at bottom of rear seat	2 bolts per cover.
	Install
8	Retrofit power supply wiring harness		AZ82.70-P-0001-04GX
9	Connect wiring harness of illuminated door sill moldings (1)		AZ82.20-P-0001-02GX
10	Clip illuminated door sill moldings (1) into door sill trim	Make sure that the wiring harness for the illuminated door sill moldings (1) is not damaged when installing the illuminated door sill moldings (1).
11	Carry out function check
12	Install in the reverse order
13	Document retrofitted equipment via vehicle documentation (VeDoc)	Attach "Illuminated door sill moldings retrofitted as per AZ82.20-P-0001GX " note under field organization text for design group 82.