Remove/install anti-roll bar on rear axle - AR32.35-P-2210GX

MODEL 461

MODEL 463 with CODE (979) Special protection version

Illustrated on right side of vehicle

Fig 1: Identifying Rear Axle Anti-Roll Bar Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Illustrated on right side of vehicle

Fig 2: Identifying Rear Axle Anti-Roll Bar Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

MODIFICATION NOTES

11.10.04

Torque of fixing bracket of stabilizer bar to trailing arm.

	Remove/install
	Risk of death caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
1	Raise vehicle		AR00.60-P-1000G
2	Unscrew nuts (1)	Installation : Replace self-locking nuts (1).
			*BA32.35-P-1001-01A
3	Detach bracket (4) and mounting bar (2) from trailing arm (3)	Installation : Pay attention to correct seat of mounting bar (2) as on some models the mounting bar (2) has been offset outwards by dimension (A).
4	Loosen bolt (8) and remove anti-sway bar (5) with link rod (6)	Installation : Install new self-locking nuts.
			*BA32.35-P-1003-01A
5	Detach link rod (6) from anti-sway bar (5)	When replacing anti-sway bar (5). Installation : Replace self-locking nut (7).
			*BA32.35-P-1002-01A
	Checking
6	Check rubber mounts for wear and damage and replace if necessary
7	Install in the reverse order

ANTI-ROLL BAR

Number	Designation		Model 460, 461, 463
BA32.35-P-1001-01A	Nut, anti-roll bar mounting clamp to trailing arm	Nm	50
BA32.35-P-1002-01A	Nut, stabilizer to stabilizer bracket	Nm	90
BA32.35-P-1003-01A	Nut, stabilizer bracket to frame	Nm	90