Remove/install headliner - AR68.30-P-4300TY

MODEL 219.3

Shown on vehicle with code (414) Power glass tilting/sliding roof

Fig 1: Identifying Headliner Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Headliner Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof	Keep body parts and limbs well clear of moving parts.	AS00.00-Z-0011-01A
1	Open tilting/sliding roof	Vehicle with code (414) Power glass tilting/sliding roof
2	Remove left front sun visor		AR68.60-P-5480TX
3	Remove A-pillar paneling at top left		AR68.30-P-4050TX
4	Remove grab handle from left front roof		AR68.30-P-4330TX
5	Remove trim on left B-pillar		AR68.30-P-4700TX
6	Remove grab handle from left rear roof		AR68.30-P-4330TX
7	Remove rear left side paneling		AR68.30-P-4780TX
8	Remove paneling from left C-pillar		AR68.30-P-4490TX
9	Remove grab handle from right rear roof		AR68.30-P-4330TX
10	Remove trim on right C-pillar		AR68.30-P-4490TX
11	Remove rear dome lamp		AR82.20-P-0113TX
12	Remove grab handle from right front roof		AR68.30-P-4330TX
13	Remove paneling from right B-pillar		AR68.30-P-4700TX
14	Remove right front sun visor		AR68.60-P-5480TX
15	Remove A-pillar paneling at top right		AR68.30-P-4050TX
16	Remove overhead control panel control unit		AR82.20-P-1000TX
17	Remove inside rearview mirror		AR68.40-P-0001TX
18	Remove bolts (3) and remove inside rearview mirror carrier (2) from headliner (1).
19	Unclip carrier (4) upward in sliding roof cutout	Vehicle with code (414) Power glass tilting/sliding roof
20	Remove windshield		AR67.10-P-1000Y
21	Expose electric wiring harness (5) up to electrical connectors (6)	Replace cable tie and damaged retaining clips.
22	Separate electrical connectors (6)	Number of electrical connectors (6) depends on vehicle equipment.
23	Detach Velcro fasteners (7) of headliner (1) from rear
24	Slightly lower headliner (1) on sliding roof cutout and pull out of rear roof edge toward front.	Vehicle with code (414) Power glass tilting/sliding roof. Ensure that headliner (1) is seated properly.
25	Remove headliner (1) from vehicle toward front through windshield aperture and lay down on clean surface.	Remove headliner (1) with aid of helper.
26	Prepare roof paneling (1) for installation	Only when replacing headliner (1).	AR68.30-P-4305TX
27	Install in the reverse order
28	Position edge guard in area of headliner (1) using assembly wedge		Figure

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA