Preparations for distance and comparison measurements - AR40.30-P-0401SX

MODEL 216, 221.0 /1 

Shown on model 221 

07

Fig 1: Identifying Mount, Threaded Stud, Left And Right Supports, Retaining Bolt With Bubble Level Shims And Rear Engine Crossmember

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Adjustment Dimensions Of Left And Right Side Supports (Shown On Model 221)

Courtesy of MERCEDES-BENZ USA

MODIFICATION NOTES

12.3.08	Value changed: Bolt for rear engine crossmember to body
29.5.08	Value changed: Bolt for rear engine crossmember to body

	Removing
1	Align the vehicle	Align the vehicle horizontally in the longitudinal direction by loading with weights as appropriate. Measure vehicle inclination across the door sills, e.g. using a spirit level
2	Detach lower engine compartment paneling	Model 216, model 221 except code Z07 top protection	AR61.20-P-1105SX
		Model 221.1 with code Z07 Top protection	AR61.20-P-1105SXS
3	Remove the two bolts in the rearmost threaded holes in the rear engine crossmember (63).
4	Turn in threaded bolts (07n) of suspension (07) with shims (1)	Use washers (1), to ensure that the threaded stud (07n) fits correctly into the rear engine crossmember (63).
			*170589006300
5	Insert and adjust hanger (07)		AR40.30-P-0401-01SX
			*170589006300
6	Insert telescopic measuring rod (06) with connecting parts onto retaining bolt using bubble level (024b)	Use relevant measuring bolt and measuring tip (024) for the corresponding distance or comparison measurement.
			*124589086300
			*124589011900
			*124589021900
			*168589076300
	Measure
7	Carry out distance and comparison measurements on front and rear axles		AR40.30-P-0402SX
	Install
8	Detach cradle (07) and threaded bolts (07n)		*170589006300
9	Screw in bolts of rear engine crossmember (63)	Model 216	*BA22.10-P-1007-03C
		-	-
10	Install lower engine compartment paneling	Model 216, model 221 except code Z07 top protection	AR61.20-P-1105SX
		Model 221.1 with code Z07 Top protection	AR61.20-P-1105SXS

ENGINE SUSPENSION, ENGINE MOUNTS, ENGINE SUPPORTS

Number	Designation		Model 216.371/373/374 /376/377/379
BA22.10-P-1007-03C	Bolt, rear engine crossmember to body	Nm	45

ENGINE SUSPENSION, ENGINE MOUNTS, ENGINE SUPPORTS

Number	Designation		Model 216.386/394
BA22.10-P-1007-03C	Bolt, rear engine crossmember to body	Nm	45

Fig 3: Identifying Telescopic Measuring Rod (170 589 00 63 00)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Telescopic Measuring Rod (124 589 01 19 00)

Courtesy of MERCEDES-BENZ USA

Fig 5: Identifying Set Of Measurement Fixtures (124 589 02 19 00)

Courtesy of MERCEDES-BENZ USA

Fig 6: Identifying Set Of Measurement Fixtures (168 589 07 63 00)

Courtesy of MERCEDES-BENZ USA

Fig 7: Identifying Connecting Pieces (124 589 08 63 00)

Courtesy of MERCEDES-BENZ USA