Press the radius rod out of the stub axle assembly - AR33.15-P-0160-01SX
MODIFICATION NOTES
| 14.6.06 | Special tool for pressing torque strut out of steering knuckle changed |
WHEEL LOCATION, HUB
| Number | Designation | Model 216 without 4MATIC | Model 216 with 4MATIC | ||
|---|---|---|---|---|---|
| BA33.20-P-1004-01M | Self-locking nut, radius rod to steering knuckle | Stage 1 | Nm | 40 | 50 |
| Stage 2 | ∠° | 150 | 90 | ||
WHEEL LOCATION, HUB
| Number | Designation | Model 221.00/02/05/07/ 09/10/12/15/17/ 19 without 4MATIC without code Z07/Z07+Z19 | ||
|---|---|---|---|---|
| BA33.20-P-1004-01M | Self-locking nut, radius rod to steering knuckle | Stage 1 | Nm | 40 |
| Stage 2 | ∠° | 150 | ||
WHEEL LOCATION, HUB
| Number | Designation | Model 221.08/09/18/19 with 4MATIC without code Z07 | Model 221 with code Z07/Z07+Z19 | ||
|---|---|---|---|---|---|
| BA33.20-P-1004-01M | Self-locking nut, radius rod to steering knuckle | Stage 1 | Nm | 50 | 90 |
| Stage 2 | ∠° | 90 | 90 | ||
Puller 221 589 02 33 00 is required for all models.
Puller fork 221 589 03 33 00 only required for model 221 with maximum protection, code Z07
- Unscrew self-locking nut from radius rod coupling.
Installation: Replace self-locking nut.
Screw thrust washer (044a) onto the radius rod coupling.
- Press torque strut (18) out of steering knuckle (5) by turning spindle (arrow).
When pressing out, do not damage the rubber boot of the torque strut joint, otherwise the torque strut must be replaced.