Remove/install blower regulator - AR83.10-P-1200SX

MODEL 216.3, 221.0/1 

Illustrated on model 221 

Fig 1: Identifying Blower Regulator Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Blower Regulator Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Switch off ignition and withdraw transmitter key or Keyless Go start/stop button from the EIS [EZS] control unit	Keyless Go start/stop button only for vehicles with code (889) Keyless Go.
2	Remove cover below instrument panel on right		AR68.10-P-1520SX
3	Expose electrical wiring harness (1) on housing (2) of blower motor (A32m1) and detach electrical connector (3)
4	Remove bolts (4)
5	Remove housing (2) with blower motor (A32m1) from air conditioner housing
6	Unscrew bolt (5).
7	Remove blower regulator (A32n1) from housing (2) and detach electrical connector (6)
8	Install in the reverse order